This is a pair of Traxxas X-Maxx Green Aluminum GTX Shocks. The shocks come fully-assembled and include a bottle of shock oil. Springs are not included.FitsX-Maxx 6SX-Maxx 8S

This is the Traxxas DCB M41 Boat Drive Strut Alignment Tool.Compatible withDCB M41 boats

This is the Traxxas DCB M41 Boat Rudder Pushrod, Servo Horn and Hardware.FitsDCB M41 boats

This is the Traxxas DCB M41 Boat Stuffing Tube Upper and Lower Mount with Hardware. Replacement upper and lower stuffing tube mount with 4x10 stainless screws (2) and 3x10 mm stainless screws (2)FitsDCB M41 boats

This is the Traxxas Blue Aluminum Drive Strut for the DCB M41 boat. Replacement blue-anodized aluminum drive strut with self-lubricating bushingsFitsDCB M41 boats

These are the Traxxas Bandit Pink Rear Springs. These are a direct fit on the stock Ultra Shocks on the Bandit XL-5 and VXL buggies.FitsBandit VXLBandit XL-5

This is the Spektrum Tricera RHCP FPV Race Antenna. The Spektrum TriCera FPV Racing Antenna is designed to provide the Cleanest Video Signal and the maximum coverage your setup allows while providing superior durability. Spektrum RC teamed up with...

This is the Spektrum AR8010T 8-Channel Air Receiver with Integrated Telemetry. The AR8010T receiver is a feature-packed, 8-channel receiver with integrated full-range telemetry. The AR8010T features built-in connection ports for RPM, Flight Pack...

This is the RC Screwz Traxxas X-Maxx 8S (77086) Rubber Shielded Bearing Kit. Protect your off-road monster from dirt, dust, mud and grime with this high-quality rubber shielded bearing kit.Rubber Shielded Bearing Kit Features: High Quality Rubber...

This is the Dynamite Large Scale Gas Engine Safety Kill Switch. This switch allows you to cut the power to your engine from the third channel on your radio. It can also be used to cut power in the case of lost radio signal, low battery, or total...

These are the RPM Rear Suspension A-Arms for ARRMA Kraton, Talion, and Outcast trucks. These also fit Durango DEX8T truggies.This is a direct replacement for ARRMA part AR330249 and Durango part TD330707.RPM Rear A-arms for the ARRMA Kraton, Talion &...

These are the RPM "Flat" Front Suspension A-Arms for Associated B6 and B6D buggies. You can't go fast if your suspension settings don't stay locked in. With stock A-arms, the amount of slop at the hinge-pins can cause your suspension settings to wander...

This is the RPM Mini Front Bumper for Associated B6 and B6D buggies. This bumper is nearly 2" (49mm) wide and extends out 1" (25mm) in front of the chassis for excellent protection. It only weighs 7.5g! This is a direct replacement for the stock...

These are the RPM Traxxas Slash 2WD Blue LCG Nerf Bars for use on Slash 2WD trucks running the low-CG chassis. The chassis layout of the low center of gravity chassis (LCG) Slash 2wd is different than the original high center of gravity chassis (HCG),...

These are the RPM Replacement 0 and 3-Degree Rear Mounts for RPM Gearbox Housings. These are replacement 0-degree and 3-degree rear mounts for RPM #73612, #73614 & #73615 Gearbox Housings for Traxxas 1/10 scale 2wd vehicles. Each package contains 1 -...

This is the RPM Blue LaTrax Alias Landing Gear Set. This includes four landing gear legs, which add 20mm (0.8") of height. These replace the stock 6649 landing gear feet.The LaTrax Alias is a tiny, fun and competent flyer, yet suffers from ground...

These are the Traxxas 4-Tec 2.0 Split Spoke 1.9 Wide Black Chrome Rear Wheels (2). These fit all 4-Tec 2.0 cars, including the Ford GT and Mustang GT.Accessory Part For4-Tec 2.0 VXL Chassis4-Tec 2.0 XL-5 Chassis4-Tec 2.0 Ford GT4-Tec 2.0 Ford Mustang

These are the Traxxas 4-Tec 2.0 Split Spoke 1.9 Black Chrome Front Wheels (2). These will fit 4-Tec 2.0 cars such as the Ford GT and Mustang GT.Accessory Part For4-Tec 2.0 VXL Chassis4-Tec 2.0 XL-5 Chassis4-Tec 2.0 Ford GT4-Tec 2.0 Ford Mustang

These are the Traxxas Front 1.9 Response Tires and Foam Inserts for the 4-Tec 2.0 cars. These are recommended for the brushed vehicles only, including the Ford GT and Ford Mustang.Stock Replacement On4-Tec 2.0 XL-5 Chassis4-Tec 2.0 Ford GT4-Tec 2.0 Ford...

These are the Traxxas 4-Tec 2.0 Red Shock Springs (2). These can be used on all 4-Tec 2.0 vehicles, including the Ford GT and Mustang GT.Stock Replacement On4-Tec 2.0 VXL Chassis4-Tec 2.0 XL-5 Chassis4-Tec 2.0 Ford GT4-Tec 2.0 Ford Mustang

These are the Traxxas 4-Tec 2.0 Grey Ultra Shocks (Short) Complete with Spring Pre-Load Spacers (2). These will fit all 4-Tec 2.0 cars, including the Ford GT and Mustang GT. A bottle of silicone shock oil is also included.Stock Replacement On4-Tec 2.0...

This is the Traxxas 4-Tec 2.0 Hex Wheel Hubs with Disk Brake Rotors. This is a full set of four. These fit all versions of the 4-Tec 2.0, including the Ford GT and Mustang GT.Stock Replacement On4-Tec 2.0 VXL Chassis4-Tec 2.0 XL-5 Chassis4-Tec 2.0 Ford...

This is the Traxxas 4-Tec 2.0 Center Aluminum Driveshaft and Pin. This fits all versions of the 4-Tec 2.0, including the Ford GT and Mustang GT.Stock Replacement On4-Tec 2.0 XL-5 Chassis4-Tec 2.0 Ford GT4-Tec 2.0 Ford MustangAccessory Part For4-Tec 2.0...

This is the Traxxas 4-Tec 2.0 Servo Saver, Spring, and Servo Horn. This is used on both the Ford GT and Mustang GT versions.Fits4-Tec 2.0

These are the Traxxas 4-Tec 2.0 Steering Bellcranks and Hardware. These are used on both the Ford GT and Mustang GT versions.Fits4-Tec 2.0

This is the Traxxas 4-Tec 2.0 Front and Rear Camber and Toe Link Set (non-adjustable). These fit both the Ford GT and Mustang GT versions. Replacement Part For:4-Tec 2.0 AWD ChassisChevrolet Corvette StingrayFactory Five '33 Hot Rod CoupeFactory Five '35...

This is the Traxxas 4-Tec 2.0 Complete Front and Rear Suspension Pin Set. These fit both the Ford GT and Mustang GT version.Fits4-Tec 2.0

This is the Traxxas 4-Tec 2.0 Front and Rear Shock Tower Set. These are used on both the Ford GT and Mustang GT versions.Fits4-Tec 2.0

These are the Traxxas 4-Tec 2.0 Front Left and Right Suspension Arms. These fit both the Ford GT and Mustang GT versions.Fits4-Tec 2.0

These are the Traxxas 4-Tec 2.0 Rear Left and Right Suspension Arms. These fit both the Ford GT and Mustang GT versions.Fits4-Tec 2.0

This is the Traxxas 4-Tec 2.0 Front Bulkhead. This is used in both the Ford GT and Mustang GT versions.Fits4-Tec 2.0

This is the Traxxas 4-Tec 2.0 Battery Hold Down, Clip, Post and Pivot Post Screw. This is used on both the Ford GT and Mustang GT versions.IncludesBattery hold-downBattery clipHold-down postScrew pinPivot post screwFits4-Tec 2.0

These are the Traxxas 4-Tec 2.0 Foam Body Washers.Fits4-Tec 2.0

This is the Traxxas TRX-4 Scale Crawler High Range 24-Tooth Metal Output Gear.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 TacticalAccessory Part ForTRX-4 SportNote: Accessory items may require additional parts for...

These are the Traxxas TRX-4 Scale Crawler Transmission Input and Output Shafts.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 TacticalAccessory Part ForTRX-4 SportNote: Accessory items may require additional parts...

This is the Traxxas TRX-4 Scale Crawler Gearbox Main Housing, Front Housing, and Cover.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 SportTRX-4 Tactical

This is the Traxxas TRX-4 Scale Crawler Motor Plate and Upper Spur Gear Cover.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 SportTRX-4 Tactical

These are the Traxxas TRX-4 Scale Crawler Transfer Case Front and Rear Output Shafts.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 SportTRX-4 Tactical

This is the Traxxas TRX-4 Scale Crawler Transfer Case Gear Set.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 SportTRX-4 Tactical

This is the Traxxas TRX-4 Scale Crawler Front T-Lock Cable.Stock Replacement OnTRX-4 Crawler KitTRX-4 Ford BroncoTRX-4 Land Rover DefenderTRX-4 TacticalAccessory Part ForTRX-4 Sport