This is the
Futaba S9350 Digital High-Torque Servo wtih Dual Ball Bearings for 1/8 Scale Car
and Boat Use. The metal case acts as a heat sink to reduce heat and is designed
to be water and dust resistant.
- Comes with Heavy Duty
wiring that can handle Higher Current Loads
- New Metal casing which
helps to dissipate heat
- Dual Ball Bearing Output
- High Torque
- Dust and Water
- Great for 1/8 Cars or Boats Where
Higher Torque and Speed are Needed
- One year
High Torque Servo w/Small Round Horn
Four Rectangular Grommets
Four Mounting Screws
One Large Round Horn
One Six Arm
One Four Arm Horn
sec/60° @ 4.8V - .12 sec/60° @ 6V
Torque: 111 oz-in @ 4.8V - 139 oz-in @
(8 kg-cm @ 4.8V - 10 kg-cm @ 6V)
Weight: 2.1oz (61g)
Width: .8" (20mm)
Height: 1.5" (38mm)
Servo Precautions, -It is best to avoid long leads and Y-harnesses especially
with standard grade wires. If problems are encountered, consider using heavy
duty wire such as Futaba's Heavy Duty Series or Hobbico's Pro Series, minimizing
lead lengths, and/or removing Y-harnesses.
Current Drain: Futaba S9350 Servo
is Specially Designed for High-Torque and High-Speed, Therefore Very High
Current Drain Is Normal At Startup.
For Ultimate Performance
When Using This Servo Please Review The Following Points.
(1) When Using
Systems With the Battery Fail Safe Function it Has a Higher Cut-Off Voltage
Setting Which Will Cause Shorter Operation Time.
(2) When Installing the Servo Please
Check Pushrod Linkage To Make Sure There Is No Binding in Order To Prevent
Excessive Power Consumption and Decrease the Life of the Motor and
This digital servo cannot
be used with the following * AM * transmitters as the servo neutral signal is:
1310us). CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terratop,
T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.
**** Otherwise they will
work fine with current AM systems *****