This is the Castle Creations QuadPack 35-Amp Multi-Rotor ESC Set. This pack of four 35 amp Multi-Rotor ESCs is equipped with three (3) ESCs without a BEC and one (1) with a BEC*. Each ESC has optimized firmware specifically designed for Quadcopter and other Multi-Rotor platforms. Refresh rates up to 490 Hz gives your platform optimum stability and maneuverability without missing a beat. The QuadPack 35 comes preprogrammed for Multi-Rotor platforms and is recommended for platforms ranging from 450 to 650 sizes pulling up to 35 amps** and running up to 6S LiPo. As with all Castle ESCs, this product is easily programmable using the Castle Link USB adapter (sold separately).
These are the perfect way to outfit your DJI F450 or F550 multi-rotor aircraft.
Castle Creations, Inc. warrants this product to be free from
manufacturing defects for a period of one year from date of purchase.
- Four 35 amp Multi-Rotor electronic speed controls with optimized firmware designed for Quadcopter and other Multi-Rotor heli platforms ranging from 450 to 650 sizes pulling up to 35 amps, and running up to 6S LiPo battery
- Refresh rates up to 490 Hz for optimum stability and maneuverability
- Programmable using Castle Link USB adapter (sold separately)
Three ESCs without BEC
One ESC with BEC*
Requires: Battery and motor connectors
Input Voltage: 2-6S LiPo
Max Continuous Amperage at Full Throttle: 35A
BEC Voltage: 5.5V
BEC Output: 7A peak
5A continuous (always check servo draw prior to first flight)
Dimensions: 0.88 x 1.93 x 0.33" (22.4 x 49 x 8.4mm)
Weight with Wires: 0.98oz (27.8g) each
Weight without Wires: 0.42oz (12g) each
Even with all these awesome features and programmability, RC Superstore is making the QuadPack 35 available at an amazingly low price!
*This package contains one Multi-Rotor 35 with a BEC and three with no BEC. The single BEC supplies power for all 4 controllers.
**RC HOBBY APPLICATION RATING: 35 amps for the duration of a single 4,000 mAh battery pack with the ESC in contact with a 5 mph airflow of 25C (77F) or cooler air. Controller temperature must never exceed 100C (212F). Exceeding current or temperature ratings may damage components and may shorten the life of the ESC. Always verify system current draw at full-throttle. Decrease load or increase airflow to decrease the ESCís operating temperature.
***Peak indicates amperage sustainable for 0.5 seconds - long enough for most servos' current draw transients. Always confirm servo current draw before the first flight of the model.