| This is the Novak Rooster Crawler Reversible Electronic Speed Control and the Novak 55-Turn Crawler Brushed Motor. This setup is perfect for crawlers like the Axial AX10 and many others.
Features:
ESC Features:
- Two specific crawling driver profiles that feature zero reverse delay and high-powered drag brakes (or "hill or "hold" brakes)
- Built-in LiPo cut-off protection prevents batteries from going below the critical safety voltage level
- User replaceable input harness
- Heavy duty 6V/5A BEC
- Radio priority and polar drive circuitry
- High-efficiency heat sink
- Power output for optional 6V fan (available separately)
- Water resistant case
- Thermal overload protection
Crawler Motor Features:
- Designed for vehicles requiring precise movement control
- High number of turns for excellent torque and long-run times
- Dual-ball bearing for smoothness and efficiency
- 100 percent rebuildable with user-replaceable brushes and springs
- Direct-Solder Wiring Tabs for flexible soldering options
- Three factory-installed motor capacitors to reduce glitching
Includes:
Novak Rooster Crawler Electronic Speed Control with instructions
Tamiya style JST battery connector, use-replaceable input harness and double-sided tape
Novak Fifty Five Crawler Brushed Motor
Requires: Installing in vehicle and connecting motor and battery
Specifications:
ESC:
Input Voltage: 4-7 NiCd/NiMH cells (1.2V per cell) or 2 LiPo cells
Size: 1.54" x 1.18" (39 x 30mm)
Weight: 2.66oz (75.5g) w/wires; 1.57oz (44.5g) w/o wires
On-Resistance: 0.0014 ohms (forward); 0.0028 ohms (reverse)*
Rated Current: 400A* (forward)
Braking Current: 200A*
BEC: 6.0V/5.0A
Motor Limit 27-turn Brushed (at 6 cells NiMH)
Discrete Steps: 256 Forward; 256 Reverse
Battery Plug: Tamiya type
Drive Profiles: 2
Status LEDs: 2
Voltage Cut-off: 6.25V (LiPo Profiles)
*MOSFET rating at 25°C junction temperature
Fifty Five Crawler Brushed Motor:
Number of Turns: 55
Design: Stand-up Brushed
Input Voltage: 4-7 cells (1.2V/cell) or 2S Li-Poly cells
Motor Size: 2.07 x 1.42" (52.7 x 36.1mm)
Shaft Diameter: 0.125" (3.2 mm) [accepts all existing pinion gears]
Bearing: Standard 3/8" x 1/8"
Weight: 6.03 oz. (171g)
Magnet: High-Strengh Ferrite |
