This is the Futaba 7CAP 7-Channel Computer Aircraft Radio with the R138DP PCM Receiver and four S3151 Digital Servos.

FEATURES:

• 10-model memory and 6-character model naming
• Same Dial n' Key programming found on Futaba's 9C systems
• Basic menu for everyday sport flying, Advanced menu for more complicated routines
• Heli and airplane control layouts in FM or PCM
• Airplane specific features:
• Flaperon
• Flap Trim
• Air Brake
• Elevator to Flap
• Flap to Elevator
• V-Tail Mixing
• Elevon Mixing
• Aileron to Rudder
• Snap
• Mode Select feature
• Fail Safe (in PCM mode only)
• Adjustable throttle cut
• Throttle curve normal (5 points)
• Pitch curve normal (5 points)
• Three programmable mixes
• VR switch controls proportional 7th channel
• EEPROM memory feature retains settings even when transmitter battery is disconnected or removed Stick Mode Select Feature-IMPORTANT, For full mode changes, transmitter must be sent to the Futaba Service Center
• Dual Rates on 4 Channels
• Triple rates available if using the 3 position switch
• Full function micro (square) trainer system, use FUTM4415 or FUTM4420 (training system only works in FM mode)
• One year limited warranty

INCLUDES:
One Futaba 7CAP 7-Channel Aircraft Radio with Four S3151 Digital Servos, FUTM0310R138DP PCM receiver, FUTL0802, FUTL0803
600mAh NT8S600B Tx battery, FUTM1457
600mAh NR-4RJ Rx battery, FUTM1280
FBC-19B (4) Wall charger, FUTM1830
Transmitter and receiver crystals
Servo accessory bag, frequency flag set, neck strap, ON/OFF switch, and instruction manual

REQUIRES:
Charging batteries overnight before use

SPECS:
Transmitter:
Transmitting Frequency: 72MHz band
Modulation: FM/PPM or PCM, switchable
Power Supply: 9.6V NT8S600B NiCd battery
Current Drain: 250mA
FP-R138DP PCM Dual Conversion Receiver:
Receiving Frequency: 72MHz band
Intermediate Frequency: 10.7MHz & 455kHz
Power Requirement: 4.8 - 6V NiCd battery
Current Drain: 16mA
Size: 2.56"x1.42"x0.85" (65x36x21.5mm)
Weight: 1.42oz (40.3g)
S3151 Standard Size Digital Servo:
Control System: Pulse width control, 1.52ms neutral
Power Requirement: 4.8V
Output Torque: 43 oz-in (3.1 kg-cm) at 4.8V
Operating Speed: 0.21 sec/60° @ 4.8V
Size 1.59"x0.79"x1.42" (40.5x20x36.1mm)
Weight: 1.48oz (42g)

COMMENTS:
For additional helpful information, consider purchasing the Traplet Publications Futaba 7C The User's Guide, TPNZ1007.