Home > Cars, Trucks, & Parts > Traxxas >

RPM Center Skid Plate for Traxxas T-Maxx 3.3, E-Maxx 16.8V & Brushless
RPM Center Skid Plate for Traxxas T-Maxx 3.3, E-Maxx 16.8V & Brushless


 
Our Price: $7.19


Product Code: RPM80892
Qty:

Description
 
This is the RPM Black Center Skid Plate for the Traxxas T-Maxx 3.3, E-Maxx 16.8V, and E-Maxx Brushless trucks

Fits: T-Maxx 3.3 (4907 & 4908 only - see bottom for version identification), E-Maxx 16.8V, E-Maxx Brushless

RPM designers carefully scrutinized a well-run T-Maxx to see exactly where all of the major abrasion points along the bottom of the truck lie. It’s those areas that we concentrated our efforts for maximum protection. RPM skid / wear plates offer more outstanding features than anything else available:
  • Ties together the chassis braces for added strength and rigidity.
  • Reduced sliding friction along smooth, grooved surfaces.
  • Recessed screw holes eliminate damage to the screw-heads.
  • A unique, matched groove appearance from the front of the truck to the rear.
  • Dirt and debris protection all along the driveline.
  • Extended area protects the disc brake from damage.
  • Outstanding wear resistance from our bulletproof nylons.
  • Smooth radii deflect the most devastating of impacts.
  • Extended along the length of the chassis braces blending with our rear plate, providing unmatched protection for the entire driveline
  • Complete with all necessary mounting screws (heat-treated, flathead hex screws) and instructions.
  • Pricing at a fraction of the cost of aluminum skid plates. 100% guaranteed against breakage.
Competitive performance at intelligent prices. Nothing compares to the value and strength of RPM performance skid / wear plates.

Version Identification: Not sure if these are the correct skid plates for your truck? There’s an easy way to tell. If your chassis braces (Traxxas #4923) do not have the word “MAXX” molded into it, these are the correct version skid plates for you. If “MAXX” is present, you need RPM #80892 or #80895.

Average Customer Review: 5 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
 
RPM Center Skid Plate January 31, 2017
Reviewer: Ron from Newport, TN United States  
This center skid plate is nice to use with the RPM front and rear RPM skid plates and RPM Bulkheads as well. If you are installing this on the 16.8 volt E-maxx, you are supposed to remove your stock center skid plate so that it can sit more flush with the rear RPM skid plate.

I wanted to keep my stock center skid on as well because it covers the transmission better, so I ground down the alignment tabs on the RPM center skid plate to allow it to sit flush on top of my stock center skid plate. Grinding the tabs down also allowed the RPM center skid to sit flush with the rear RPM skid plate allowing me to keep my stock center skid plate on and still use the RPM center skid plate over it.

The reason you want your center skid plate flush with the rear skid plate is because you don't want your rear skid plate hooking on the ground and sometimes flipping your truck after a good jump.

Was this review helpful to you?