This is the E-Flite Power 10 Brushless Outrunner Motor, 1100Kv. The Power 10 is designed to deliver clean and quiet power for 10-size sport and
scale airplanes weighing 32 to 48 ounces (910 to 1360 grams), 3D airplanes
weighing 28 to 36 ounces (790 to 1020 grams), or models requiring up to 375
watts of power. It’s an especially good match for the E-flite Brio 10 for high
speed F3A precision or artistic aerobatics.
You will need40A ESC6- to 10-cell Ni-MH/Ni-Cd or 2–3S Li-Po10x5 to 12x6 electric props
SpecificationsType: Brushless outrunner motorSize: 10-sizeBearings or
Bushings: One 5 x 14 x 5mm Bearing, and One 5 x 11 x 5mm BearingWire
Gauge: 16Recommended Prop
Range: 10x5-12x6Voltage: 7.2-12RPM/Volt
(Kv): 1100Resistance (Ri): .043 ohmsIdle Current
(Io): 2.10A @10VContinuous Current: 32AMaximum Burst
Current: 42A (15 sec)Cells: 6-10 Ni-MH/Ni-Cd or 2-3S
Li-PoSpeed Control: 35-40A brushlessWeight: 122 g (4.3
oz)Overall Diameter: 35mm (1.40 in)Shaft Diameter: 5mm
(.20 in)Overall Length: 43mm (1.60 in)
* Maximum Operating Temperature: 220 degrees Fahrenheit
cooling is required for all motor operation at maximum current levels.
Maximum Burst Current duration is 15 seconds. Adequate time between maximum
burst intervals is required for proper cooling and to avoid overheating the
* Maximum Burst Current rating is for 3D and limited motor run
flights. Lack of proper throttle management may result in damage to the motor
since excessive use of burst current may overheat the motor.
Enter your email address!