This is the Castle Creations Sidewinder SCT Short-Course Edition 1410 (3800Kv) Brushless Motor (with 1/8" shaft) and Sidewinder SCT Waterproof Speed Control Combo. This combo is perfect for 2WD and 4WD short-course trucks like the Traxxas Slash 2WD, Slash 4x4, HPI Blitz, Associated SC10, and other similar vehicles.
The Sidewinder SCT is ready to run out of the box, but it is completely Castle Link compatible too - drivers can use their Castle Link and Windows PC to tune and tweak all their favorite settings such as brake and throttle curves, throttle response, drag brake and many other parameters that add up to an incredible RC driving experience.
- Sidewinder SCT Short Course Truck Edition combo: an exciting combination of a new motor design from Castle & Steve Neu and a new waterproof Sidewinder SCT controller
- Designed for 2WD and 4WD 1/10 scale short course trucks
- Neu-Castle 4 pole 1410 1Y motor has 50% more torque than Castle's CM36 series
- The Sidewinder SCT controller offers a 40% increase in power handling over the previous Sidewinder 1/10 but keeps the same great Sidewinder affordability.
- 3800kV Castle 1410 Y brushless motor with cooling fan and four magnets on the rotor giving a 20% increase in torque over most other motors in this class with only two magnets
- Sidewinder SV2 SCT electronic speed control with proportional brake, reverse with lockout and programmable low voltage cutoff with Auto LiPo Detect set as default
- Motor and ESC are wired together-no connectors needed
- Add some cool to your motor with the included CC Blower fan and shroud and you are ready to run with the big boys.
2WD SCT CORR trucks on 2S
4WD SCT / CORR trucks on 2S
Max recommended vehicle weight = 6.5 pounds
Sidewinder SCT combo includes:
Sidewinder waterproof SCT Edition ESC with Fan
Neu-Castle 1410 1y 3800 kv motor
Blower fan and shroud for included motor
Cells: Controller and motor max 2S. Controller alone with motor of lower KV max = 3S.
Reversible: May be set with reverse lockout for racing.
Low Voltage Cutoff: Programmable
ESC Dimensions (LxWxH): 1.8" x 1.4" x 0.9" (46x35x23mm)
Pole Count: 4
Shaft Diameter: 1/8" (3.2mm)
Connector Type: Motor connected to controller with 4mm bullets (Installed)
*Not intended for operation while submerged in liquid. If unit is operated in wet conditions, rinse with fresh water to remove dirt or corrosives, then fully dry unit.